pH CONTROLLER

554200

Designed to be used for pH control where Chlorine Generator (Salt System) is installed.

INCLUDES: Controller, flow cell with flow switch, pH probe, 3/8” tubing, fittings.

Probes: One-year limited warranty
Controller: One-year limited warranty

on electronics
NOTE: It is recommended that an in-line

filter system be used before the flow cell

554217

INCLUDES: Controller, flow cell with flow switch, pH probe, 40’ of 3/8” tubing, fittings and one 32 GPD peristaltic pump.

• Mounting board is pre-drilled and ready to mount on wall

• NOTE: This system is designed to control pools up to 100,000 gallons. Larger pools may require

larger GPD peristaltic pumps

pH Monitoring from 6.8 pH to 8.2 pH with .1 pH Resolution
Set Level from 7.0 pH to 8.0 pH
Dosing Options from Continuous to up to 15 Minutes
Factory Set 5 Minute Delay in Timed Feed Mode
Factory Set High (8.0 pH) and Low (7.0 pH) Alert Levels
Single Button Calibration
Overfeed Alert after 30 Minutes in Continuous Feed and 30 Feed Cycles in Timed Feed Mode (Requires Hard Reset)